Intrusion Prevention FAQs

From Edge Threat Management Wiki - Arista
Revision as of 19:38, 15 May 2019 by Cblaise (talk | contribs)
Jump to navigationJump to search

Is Intrusion Prevention based on an open source project?

Yes, Intrusion Prevention is based on Suricata.

Why is there no reference information for a specific signature?

If there is no information link available for a specific signautre, you can try searching the signature ID at Suricata Rules for more info.

Why aren't most of Intrusion Prevention's signatures blocked by default?

Because many signatures can block legitimate traffic in addition to malicious exploits we don't enable blocking by default.

You're free to change the action of any rule to block signatures as you see fit for your network.

Can Intrusion Prevention rules be configured differently within different policies?

No. Intrusion Prevention applies to all traffic flowing through Untangle so different configurations are not possible.

What is the difference between rule block actions?

Enable Block if Recommended is Log will only enable a signature to Block if its Recommended Action is Log.

Enable Block will unconditionally set all matching signatures to Block.

The difference is that a signature's Recommended Action (almost always either Log or Disabled) is carefully considered by the signature provider. A rule set to Enable Block if Recommended is Log will likely set that smaller and "safer" set of signatures to Block whereas Enable Block will likely set a larger set of signatures with more potential to disrupt legitimate traffic on your network.

How can I exclude network processing for signatures

Create a variable with the network you wish to exclude in standard CIDR format such as 192.168.1.0/24. If you have multiple networks to exclude, create a comma-separated list surrounded by square brackets such as [192.168.25.1.0/24,10.10.0.0/24].

Next, create a rule to match the signatures you wish to exclude. For Action select Whitelist and then specify the variable you created to either Source or Destination networks.

NOTE: Unlike other Rule actions, the Whitelist action doesn't enable logging/blocking for rules. Signatures affected by Whitelist rules will still be processed by the first matching non-Whitelist Rule.